The linked 1N5819 is an STMicroelectronics part, so I’ll use ST’s ratings rather than mix manufacturers. I’ll also distinguish polarity compatibility from a guaranteed fit on the existing footprint.
For 1n5819 vs 1n4007, the main difference is low forward drop versus high reverse-voltage capability. Choose 1N4007RLG for higher-voltage, slow rectification and 1N5819 for low-voltage circuits where forward loss or switching behavior matters.
This comparison uses the exact onsemi 1N4007RLG axial ordering code and the STMicroelectronics 1N5819 axial DO-41 device identified by the linked Flux part. It does not combine ST ratings with another manufacturer's 1N5819. The onsemi ordering table includes 1N4007RLG; ST lists the base 1N5819 packing and the separate 1N5819RL tape-and-reel option.
I used onsemi’s exact axial device and STMicroelectronics’ counterpart, matching the linked Flux part.
Values left out:
Numerical recovery time, recovery charge and capacitance comparison: no verified matched-condition values established.
A separate ST DC reverse-voltage rating: the reviewed table specifies repetitive peak reverse voltage instead.
Fixed formed-lead pitch: not established by the package drawings.
An inferred millisecond duration for onsemi’s surge rating: the table states only “one cycle.”
Pinout risk: Both drawings identify the banded end as cathode. ST does not assign numeric terminal identifiers, so library A/K pad mapping and mechanical fit still require checking before substitution. I did not certify the project footprint or run circuit tests.