Noise Level Detection Schematic
I am making a noise level detection using a Node MCU Esp32S along side the sensor LMV342. The sensor has 5 pins that will be connected to the development board. Make me a schematic of this connection to filter the noise as much as possible between the two devices
Thought for 4 mins 18 sec
Here are the parts we’ll add for your noise-level interface:
- NodeMCU-32SLua – ESP32-S dev board
- LMV342ID – dual low-voltage op-amp
- 10kΩ Resistor – for RC input filter
- 100nF Capacitor – for RC filter & decoupling
- 10µF Capacitor – bulk decoupling on VCC
- Pin Header 01×05 2.54 mm – 5-pin connector for sensor lines
Shall I go ahead and place these on the schematic?
No schematic yet
Talk to Flux to get started.
