Project Start
Thought for 15 mins 57 sec
Created a thread
Pocket Reader Button Rework
Needs input
View Thread
flux
The electrical conversion is underway; the remaining work is the mechanically sensitive rear-button placement and rerouting around the Feather/battery volume. I’m continuing through the validation pass rather than stopping with a partially revised board.
Thought for 9 mins 49 sec
Awaiting 1 background task
"Pocket Reader Button Rework" stopped, moving forward.
Thought for 7 sec
flux
The rework executor stopped before completing the revision. I’m checking exactly what landed, then I’ll finish the two-button schematic/firmware changes and independently verify the rear placement and routing.
Thought for 2 sec
Referenced guidance.
Thought for a moment
"Pocket Reader Button Rework" completed.
Worked for 44 sec
flux
The two-button revision is complete and verified:
- Rotary encoder removed.
- Rear-left SW3 = Previous, connected to Feather GPIO26.
- Rear-right SW4 = Next, connected to Feather GPIO25.
- Both 12mm tactile buttons are mounted on the PCB bottom/rear side.
- Power switch and corrected portrait 1×9 display header remain.
- Board is fully routed with 0 airwires and no open ERC/DRC warnings or errors.
The battery is an enclosure-mounted item, not PCB-mounted. Next, the firmware and enclosure should be finalized around the rear buttons and 61.9 × 33.3 × 3.2mm battery.
Waiting for input
