The component with designator U2 is an Adafruit DHT11 basic temperature-humidity sensor. It is a simple and cost-effective sensor that uses a capacitive humidity sensor and a thermistor to measure the surrounding air and spits out a digital signal on the IO pin (no analog input pins needed).
Here's the role of each pin on the DHT11:
VCC: This is the power supply pin. It typically requires a voltage between 3.3 to 5V to operate.
IO: This is the data output pin. It transfers temperature and humidity data to the microcontroller or another interface.
NC: As the name suggests, NC stands for "Not Connected". It doesn't serve a purpose in this module.
GND: This is the ground pin. It should be connected to the ground of your circuit.
This sensor is often used in projects where you need to measure temperature and humidity. Response time is 1 second for temperature and more than 5 seconds for relative humidity, with the data being output every 2 seconds.
To switch data lines on/off by controlling the flow, you can use an N-Channel MOSFET. The 2N7000 is a commonly used due to its ease of use, reliability, and availability. It is suitable for logic level usage, so it can easily interface with microcontrollers or other logic devices.
Here are the key connections for using a 2N7000 in your circuit:
Drain (D) - Connect this to the IO pin of U2 (DHT11).
Source (S) - Connect to the ground of your circuit.
Gate (G) - Connect this to the controlling signal source, i.e. whichever device decides when the data line should be enabled/disabled.
Remember, when a high voltage is applied to the Gate (relative to the Source pin), current can flow from Drain to Source, making the data line active. When the Gate voltage is low, the current flow from Drain to Source is blocked, effectively disabling the data line.
Do bear in mind that the 2N7000 has a maximum Vds of 60V and a maximum Id of 200mA, which should be well within the operating range for the DHT11 sensor. However, always check your specific use case and datasheets for both the transistor and other components for compatibility.
One last consideration: when using MOSFETs, it's highly recommended to use a pull-down resistor on the Gate to ensure it doesn't float, which can lead to unpredictable behavior. A value around 10kΩ is a common choice for this pull-down resistor.
U1 is the LM35CZ/NOPB, which is a precision IC temperature sensor from Texas Instruments. It generates an output voltage linearly proportional to the Centigrade temperature. The LM35 series are rated to operate over a -55°C to 150°C temperature range.
Here's how each of its pins function:
Pin 1 (+VS): This is the supply voltage pin. It requires a DC input voltage to power the sensor. It typically operates at a voltage range of 4V to 30V.
Pin 2 (GND): This pin is connected to the ground of your circuit.
Pin 3 (Vout): This is the output pin. It outputs an analog voltage signal that is linearly proportional to the temperature, with a scale factor of 10mV/°C.
This part would be used in a circuit where you need to measure temperature.
hassadi
copilot
hassadi
copilot