Chat


How can I help you?

Explain project
Write a project description
Find schematic issues

Schematic of USB-B to UART
4
i want to configure cBUS0 to be vebus sens and to connect it with adum, can you ...

@copilot i want to configure cBUS0 to be vebus sens and to connect it with adum, can you tell me how to connect with adum
2y
It seems you'd like to configure the CBUS0 pin of your FTDI IC (IC1) to act as a VBUS sensing function and interface it with your ADuM IC (IC2).
However, note that VBUS Sens isn't a standard option in the CBUS functions of FT230XS (IC1). You could instead use the CBUS0 pin to provide a Power Enable (PWREN#) functionality, which goes low when the device is powered (USB configured).
Please remember to program the CBUS functionality using MProg or FT_Prog utility provided by FTDI.
Given this information, to connect IC1 to IC2, you could implement the following:
  1. Connect the configured CBUS0 (PWREN#) on IC1 to the Power-Down Enable (PDEN) pin of the IC2.
    This allows the FTDI chip to signal the ADuM4160 when to power down.
Also, please remember to apply appropriate pull-up or pull-down resistors based on your system requirements. Let me know if you need further assistance.
2y
is SPDEN = SPD?
2y
Yes, you're right. On the ADuM4160, SPD (pin 13) is equivalent to the Power-Down/Speed Control (SPDEN) pin.
This pin, when tied to GND, sets the ADuM4160 to Full-Speed operation (~12 Mbps). If left disconnected or tied to VDD, the device operates in Low-Speed (~1.5 Mbps). You can connect your device's speed control logic to this pin to dynamically control its speed.
2y
is correct now?
2y
I'm sorry but without a description of the changes you've made or the current state of your project, it's difficult for me to confirm if your recent changes are correct.
However, on a generic note, if you have connected the CBUS0 pin (on IC1, FT230XS-R) configured as a Power Enable (PWREN#) to the PDEN pin (on IC2, ADUM4160), and you have understood the operation of the SPD (SPDEN) pin on ADUM4160, you are probably on the right track.
Always make sure to double-check the connections based on both chips' datasheets and the application requirements. Also, check the availability of the necessary ancillary components (like resistors, capacitors etc.) and their values for the desired optimal operation.
Do provide more detail in case you want a more specific feedback.
2y
C2
Capacitance
47pF
R5
Resistance
4k7 Ω
C1
Capacitance
47pF
IC2

USB-B to UART

USB-B to UART thumbnail