nice, can you make the bottom of the board meet that 4.6mm protrusion? I think four legs on each corner should work
Thought for 16 sec
flux
30 days ago
I’ll add one leg at each of the bottom enclosure’s four corners, extending 4.6 mm downward so their contact faces sit level with the new mounting-boss protrusion. I’ll keep the PCB, screw holes, and connector clearances unchanged.
Thought for 11 mins 37 sec
30 days ago
"PCB Mount Fit Blocker" completed.
Thought for 3 mins 5 sec
30 days ago
"Corner Foot Geometry Review" completed.
Worked for 45 sec
flux
30 days ago
Added four corner legs, each 4.6 mm tall, with their bottom faces exactly level with the mounting-boss protrusion; the PCB position, connector openings, and screw access remain unchanged. Download updated bottom-cover STL.
An open-side-up print still needs removable supports beneath the raised floor; check flatness after printing, as noted in the print notes.