Adding Resistors to Design
0:52
Thought for 4 sec
Thought for 6 sec
Thought for 17 sec
Thought for 10 sec
Thought for a moment
I’ll add four resistor components and label them R1–R4, leaving them unconnected.
Before I start, a couple quick details:
- What value and tolerance should I set for each (e.g., all 1 kΩ, 5%)?
- Footprint type: SMD (which size) or through-hole (axial 6.3x2.5 mm)?
- If values differ across the four, please specify per designator.
Click Start on the plan bar when ready.
Plan
- Create a resistor chain where a 27kΩ resistor is connected in series with a 1kΩ resistor, with the 1kΩ resistor tied to ground. This chain will be implemented in a new project since the current published project cannot be edited directly.
#Implementation plan
- Create a new project or a separate design module for the resistor chain to avoid modifying the published project.
- Add components:
- Add a generic 27kΩ resistor to the project.
- Add a generic 1kΩ resistor part (existing through-hole part) to the project.
- Wire the components:
- Connect the 27kΩ resistor’s output terminal to the input terminal of the 1kΩ resistor.
- Connect the output terminal of the 1kΩ resistor to the GND net.
- Validate design integrity by running ERC/DRC checks.
- Document the resistor chain configuration in the project description for future reference.
#Success criteria
- The resistor chain (27kΩ to 1kΩ) is added in a new editable project module.
- The 1kΩ resistor is properly connected to ground.
- ERC/DRC checks pass without errors for the new chain configuration.
Put a 27k ohm resistor connected to a 1k ohm resistor to ground
0:36
Thought for 5 sec
Analyzing in depth.
I've made a plan, and started work on it.
Plan
- Create a resistor chain where a 27kΩ resistor is connected in series with a 1kΩ resistor, with the 1kΩ resistor tied to ground. This chain will be implemented in a new project since the current published project cannot be edited directly.
#Implementation plan
- Create a new project or a separate design module for the resistor chain to avoid modifying the published project.
- Add components:
- Add a generic 27kΩ resistor to the project.
- Add a generic 1kΩ resistor part (existing through-hole part) to the project.
- Wire the components:
- Connect the 27kΩ resistor’s output terminal to the input terminal of the 1kΩ resistor.
- Connect the output terminal of the 1kΩ resistor to the GND net.
- Validate design integrity by running ERC/DRC checks.
- Document the resistor chain configuration in the project description for future reference.
#Success criteria
- The resistor chain (27kΩ to 1kΩ) is added in a new editable project module.
- The 1kΩ resistor is properly connected to ground.
- ERC/DRC checks pass without errors for the new chain configuration.
Use 0603 footprints
Add 5V input
Add midpoint test point
Calculate divider output
Run ERC check
Finished working
To get started, talk to Flux or create a New Document.
Welcome 👋
Flux accelerates your PCB design with AI.
Create your account to start using this component and bring your ideas to life.