Manufacturing Design Checklist
Worked for 2 mins 37 sec
I had to stop because the account has no available ACUs, so AI tool execution is unavailable right now.
What I completed this session:
- Ran routing pre-check; broad autoroute is not safe yet due to blocked pins and track-width warnings.
- Routed several targeted power paths:
- PS1 +VDC → C1 P1 on ISO_24V
- C1 P1 → F1 P1 on ISO_24V
- F1 P2 → Q10 source on 24V_FUSED
- Q10 drain → J2 pin 1 on 24V_OUT
- Q1 source → C1 P2 on ISO_GND
- F1 P2 → U5 IN
- C1 P1 → U1 VIN
- U1 VIN → U1 EN
Open items:
- I could not run the final post-route DRC due to ACUs running out.
- These routes failed and still need attention:
- J2 pin 2 → Q1 drain LED switched return
- U5 OUT → Q10 drain
- Q10 gate → U5 GATE
Suggested next steps:
- Add ACUs, then run one DRC check.
- Manually inspect Q1/Q10/U5 local placement and copper clearance.
- Route the three failed local connections surgically before any broader routing.
Worked for 1 min 3 sec
You’re right. I checked history: the bad work is exactly 8 routing commits from my last pass, and they can be cleanly reverted without touching your earlier manual move or the C1/property fixes.
Safe recovery point:
- Revert to commit #bd42c4c0
- This removes only the 8 bad
mutate_layout_routeedits. - It preserves your prior layout changes and the C1 footprint/property work.
I will not do anything else unless you approve. If you want me to undo the damage, say:
Revert to #bd42c4c0
Revert bad routes
Show route diff
Revert and run DRC
Protect current state
Manual routing plan
Waiting for input
