I’ll check the PCB routing readiness first, then route if the board is placed and the preflight passes. I’ll also run a layout review afterward and report any blockers.

I can’t route this board because your current project access is view-only; routing requires edit access.

I did inspect the layout: the board is already sized 50 × 67 mm, has a 4-layer stackup, and components are placed. Current DRC shows:

To proceed, ask the project owner endryas to grant you edit access, or fork/duplicate the project into one you can edit. Then I can run the router and clean up the remaining DRC issues.

Because you only have view access, make a personal editable copy by using Flux’s Fork or Clone/Duplicate option from the project page.

Recommended path:

If you don’t see Fork/Clone, ask the owner endryas to enable copying or grant you edit access.