ESP32 I2C PCB Shield

I want to design a board which has same connector as esp32 dev kit c where I am connecting ada fruit fuel gague, ada fruit battery charger lip, ada fruit bme280, waveshare oled display 0.91" size and a lipo battery. I have already working prototype but i want to build a pcb which cna directly sit on the esp32 and has jst or stemma connectors which are connected on gpio 21 and gpio 22 for scl and sda and vcc gnd to relevent pin so i can connect my sensors and a other components connect via connectors on the designed pcb

image.png

Thought for 4 sec

flux

I reviewed your concept: an ESP32 DevKitC plug-on shield carrying shared I²C connectors for GPIO21/SDA and GPIO22/SCL, plus power and ground, intended for the Adafruit fuel gauge, LiPo charger, BME280, Waveshare 0.91″ OLED, and a LiPo battery.

No project changes were made. Before implementation, the exact ESP32 DevKitC revision/header spacing and each module’s connector pin order must be verified; the design also needs a safe battery/USB charging and power-path architecture so the ESP32 and charger cannot back-feed each other. The current project remains unchanged with its existing RP2040 component and single net.

Execution stopped because your ACUs ran out.

Files

Schematic

Layout

3D View

Raspberry Pi Pico | End-to-end AI Design Tutorial [Example]