Wearable Device Design
I want to build a wearable device that ustilizes the ublox nore-b206-00b module and npm2100-caaa-r7 pmic for power. I will also have a bma400 accelerometer.
Thought for 4 sec
The project is currently blank; no schematic components or nets have been added. Your intended wearable architecture is:
- u-blox NORA-B206-00B BLE module
- Nordic nPM2100-CAAA-R7 PMIC
- Bosch BMA400 low-power accelerometer
Remaining work: confirm the battery type/capacity, charging connector, required sensors or outputs, programming/debug interface, and target board dimensions; then create and verify the power, SWD, I²C, decoupling, antenna-keepout, and charging circuitry.
I can’t build the schematic right now because your account has no available ACUs.
Clarify battery and charger
Add programming header
Plan the sensor interface
Set layout constraints
Review part datasheets
No schematic yet
Talk to Flux to get started.