Custom Flight Controller PCB Design


  • Added 3x 5019 as TP1, TP2, TP3
  • Added 1x B2B-PH-K-S(LF)(SN) as J1
  • Added 4x BM02B-GHS-TBT(LF)(SN) as CN1, CN2, CN3, CN4
  • Added 2x Pin Header 01x03 2.54mm Vertical as J1, J2
  • Added 1x 61300411121 as J3
  • Added 2x SML-D13FWT86C as LED1, LED2

Worked

Work completed:
  • Project description and system architecture documented per requirements.
  • Major ICs added: ESP32-WROOM-32 and MPU6050.
  • Power-in stage built: 1–2 A polyfuse, TVS diode, P-MOSFET ideal-diode reverse protection, 3.3 V LDO regulator.
  • Four logic-level N-MOSFET motor driver stages added.
  • Supporting passives placed: decoupling and bulk capacitors, pull-ups, gate resistors, pulldowns, ADC divider resistors, snubber caps.
Remaining tasks:
  • Connectivity: add power, motor, UART/I2C/PPM-SBUS headers and status LEDs; make all net connections.
  • Schematic review: verify completeness and component ratings.
  • PCB layout prep: assign footprints, set 2-layer stackup, define board outline (40 × 40 mm), choose power/ground planes.
  • Define layout rules, place components (IMU centre, antenna keepout, star ground), and route nets.
  • Perform ERC/DRC; generate BOM, Gerber files, and 3D render.
Success criteria:
  • Schematic component selection ✓ but wiring incomplete.
  • PCB layout, BOM, Gerbers, 3D render ✗.
  • Power management elements in place ✓; proper placement and high-current routing pending.
Next step:
Proceed with Step 4 (Connectivity): add connectors and complete net wiring in the schematic to lay the groundwork for PCB layout.

Flux stopped


Schematic of Respectable Brown Esper Photo Analyser
U1
Schematic Not Placed

The schematic has not been placed. Flux can arrange symbols and draw wires to be more readable. This takes about 10–60 mins.

Respectable Brown Esper Photo Analyser