PCB Configuration Confirmation

flux

Audit only completed. No changes were made.
Schematic pin connections J1

Table

PinConnected net in schematic
1No net connected
2No net connected
F1

Table

PinConnected net in schematic
1No net connected
2No net connected
PCB audit

Table

CheckResult
3. Do J1 and F1 have copper pads visible in the PCB layout?Yes
4. Are there any airwires shown between J1 and F1?No evidence of a J1-F1 airwire
5. Are J1 and F1 footprints fully loaded in the PCB canvas?Yes
Notes
  • Both footprints are present in PCB with visible pads:
    • J1: pads 1 and 2
    • F1: pads 1 and 2
  • The footprints also include silkscreen/shape data, so they appear fully loaded.
  • The schematic audit tools returned no matching nets for J1 and F1, so at this moment they appear unconnected in the schematic.

Applied changes.

0:01

nets { /* no nets match filter */ }

dennismumba

dennismumba

i cant see their connecting white dots

flux

This is the most relevant entry I found related to the topic:
“To connect parts, hover over a part to reveal its terminals, then click on the white dots to begin routing mode. You don't need any tools. simply click where on the white dot to start wiring. To complete the connection, click on the terminal of the other element. Connecting parts While in wiring mode, you can also change the wire angle (elbow) direction of the route by pressing the “f” key. To cancel the routing mode, press the escape key.”
Source
In your current project audit, J1 and F1 do exist in both schematic and PCB, and their PCB footprints include pads.
Show terminal visibility
Explain hover behavior
Check schematic issues
Sign up to send

Refine this doc
Ask about this doc
Design Notes
Added passive and support components
This note records the passive/support components added to the Battery Power Entry schematic and their verified footprint bounding box dimensions.

Table

DesignatorFunction
C1Bulk capacitor on BAT_PLUS
C2Bulk capacitor on +5V
C3Bulk capacitor on +3V3
C43V3 decoupling
C10ACS712 decoupling
C12ESP32 bulk capacitor
C13ESP32 decoupling
R1Battery divider upper resistor
R2Battery divider lower resistor
R_CS1ACS712 output filter resistor
C14ACS712 output filter capacitor
R3Thermistor pull-up
NTC1Thermistor sensor
Q1Relay driver transistor
R4Relay transistor base resistor
D3Flyback diode
R7LED resistor
R_STARGNDAGND-PGND tie

    Added passive and support components

Documents

    design-notes

Assets

Assets are files uploaded to this project which can be used in various ways.

Battery Power Entry thumbnail
Welcome to your new project. Imagine what you can build here.

Properties

Properties describe core aspects of the project.

Pricing & Availability

Distributor

Qty 1

Controls