Project Start Guidance


The CR1632/QFN schematic redesign is complete and ERC-clean at 68 components / 43 nets. It now uses the DW3210 QFN, TPS63900 2.7 V rail, MAX40200 reverse-current protection, switched battery monitoring, and correct RF2 termination; all charging circuitry is removed.
Blocking issue
  • The only credible reservoir found is a 3.5 F, 20 × 10 × 22 mm supercapacitor. It supports the coin cell electrically but cannot fit inside the 25 mm golf-ball assembly.
  • A CR1632 alone cannot reliably supply the DW3210’s UWB current peaks.
Next decision
  • Use the CR1632 and external supercapacitor for a bench-only electronics prototype, or
  • Return to a compact high-rate rechargeable/custom cell for the in-ball prototype.
I have paused placement rather than creating a mechanically impossible board. Please choose the bench-only CR1632 version or the in-ball high-rate-cell version.
please proceed with in ball high -rate-cell version
I’ll convert the current CR1632 prototype into the in-ball high-rate rechargeable version while keeping the DW3210 QFN. I’ll remove the oversized reservoir, restore a protected custom LiPo power/charging path, select a compact non-BGA charging architecture where possible, then re-verify the schematic before rebuilding the 25 mm placement.
Finished execution
please pause for now
Paused. I’ll stop the active redesign thread and leave the project at its current saved state; the CR1632-to-high-rate-LiPo conversion may be partially applied, so I’ll inspect and reconcile it before resuming later.
"Rechargeable Golf Ball Tracker" stopped, moving forward.
Paused as requested. The rechargeable-cell redesign executor was stopped before completing a verified handoff, so no changes are being accepted as final.
When resumed, I’ll first inspect any partial schematic mutations, then continue the high-rate LiPo conversion and independent electrical audit.

Schematic of Compact UWB Golf Ball Tracker
C52
Capacitance
820pF
U4
Q1
Schematic Not Placed

The schematic has not been placed. Flux can arrange symbols and draw wires to be more readable. This takes about 10–60 mins.

Compact UWB Golf Ball Tracker