Attachment Review
Thought for 16 mins 14 sec
Created a thread
Raspberry Pi HAT PCB Layout
Needs input
View Thread
The HAT geometry and component placement work is still running; I’m letting the same layout engineer continue through routing and DRC rather than interrupting mid-build.
Thought for 24 mins 50 sec
The PCB layout executor completed its resumed build, but ACUs were exhausted before I could retrieve and independently verify its final report.
Remaining verification:
- Confirm HAT outline, mounting holes, and J6 mating geometry.
- Check placement, routing, ground pours, and silkscreen.
- Re-run DRC and confirm zero airwires/blocking violations before manufacturing.
Received notification from "Raspberry Pi HAT PCB Layout" that it finished — picking the work back up.
Thought for 2 sec
The Raspberry Pi HAT layout executor has completed, but I cannot retrieve or independently reconcile its output because no ACUs are available. The project may contain the finished placement/routing, but it remains unverified.
Still required:
- Inspect outline and mounting-hole geometry.
- Verify connector placement and Raspberry Pi mating alignment.
- Confirm routing, ground pours, silkscreen, zero airwires, and final DRC status.
Inspect layout and DRC
Check mechanical geometry
Review routing quality
Prepare manufacturing outputs
Waiting for input
