A Blinking LED

flux

I’ll build a hand-solderable 9V battery LED blinker using a 555 timer, add the on/off switch and LED current limiting, then run an electrical check.

flux

I’m selecting through-hole parts: a DIP 555 timer, red THT LED, SPST power switch, and 9V battery connection, with through-hole passives for timing and decoupling.

flux

Parts are selected: TI NE555P in PDIP-8, a through-hole red LED, a through-hole slide switch, and a PCB 9V battery holder. I’m adding them now with through-hole timing/decoupling parts.
Worked for 33 sec
Thought for a moment — Querying datasheet details
2/4 Add parts, set project metadata, and configure passives

Select hand-solderable parts for 9V 555 LED blinker

Add parts, set project metadata, and configure passives

Wire the 555 astable, battery switch, and LED load

Verify schematic connectivity and run electrical checks

Thought for 10 sec
Renamed 9V LED Blinker.
Read NE555P ti.com.
Updated project description.
Set Domain, Power Requirements, Human Interface and 1 more.
Thought for a moment
Evaluating project adjustments
I'm considering if I need to adjust the project properties standard. It seems like there's a warning, but it's

Demo Complete

The guided demo is finished. You watched Flux replay a real design session in this read-only project. Sign up to build your own project.

Sign up to send
No schematic yet

Talk to Flux to get started.