Project Getting Started
Thought for 26 sec
Thought for 11 sec — Evaluating active statuses
Steering Smart Coaster Layout Recovery…
Thought for 8 sec
Searching executors in /jrams623/smart-coaster-can-node~hf…
Received notification from "Smart Coaster PCB Fix" that it stopped — taking it from here.
Thought for 5 mins 52 sec
Thought for 8 sec — Troubleshooting executor issues
Referenced guidance.
Reading PCB Placement Corrections's report…
Thought for 11 sec
Thought for 8 sec
Awaiting 1 background task
Received notification from "PCB Placement Corrections" that it finished — picking the work back up.
Thought
I preserved your manually adjusted J4 and LED placement and stopped the earlier correction passes that could overwrite them. A replacement pass was dispatched to handle only the remaining U1 support, C4/U5, USB support, buck-stage, pump-stage, and antenna-keepout work.
I could not inspect or reconcile that executor’s completed changes, so their exact state is unverified. Before routing, the live board still needs a read-only check confirming:
- J4 and all LEDs remained unchanged.
- U1, C1, and R2 clear the center-hole and antenna regions.
- C4 is properly oriented beside U5.
- U6/R9/R10/U7 are suitably arranged behind J4.
- U3/L1/C18–C22/R11/R12 and Q1/D2/R7/R8 are compact and clear.
- The antenna copper keepout exists across all copper layers.
- No new overlaps, bounds errors, or center-hole violations were introduced.
Execution stopped because your ACUs ran out.
Check placement status
Review DRC issues
Verify antenna keepout
Document placement constraints
