Laser Walkie Talkie
Thought for 4 mins 58 sec
1/4 Complete and wire the full transmitter and receiver schematic
Complete and wire the full transmitter and receiver schematic
Create specification, firmware starter, and bring-up project files
Independently verify connectivity, pin mapping, safety, and ERC
Resolve any defects found by independent review
Thought for 8 sec
Referenced guidance.
Thought for 28 sec — Preparing launch executor
Steering Laser PCM Schematic…
Created a thread
Laser PCM Schematic
Needs input
View Thread
Thought for 7 sec
Awaiting 1 background task
"Laser PCM Schematic" completed.
Thought for 5 sec
The schematic completion thread finished, but I could not retrieve its final report or inspect the resulting live project before tool access ended. Therefore I cannot safely claim that any wiring, passives, corrected PAM8302A replacement, project files, or ERC fixes landed; the last independently verified state remains 17 components and 0 nets.
Still requiring reconciliation:
- Compare the thread report against the live component and net inventory.
- Confirm corrected U6 replacement and all TX/RX support passives.
- Inspect the complete microphone-to-laser and photodiode-to-speaker paths.
- Verify hardware laser-disable behavior, MCU pin mapping, power/ground, and no-connects.
- Confirm the specification, firmware starter, and bring-up plan exist and match the schematic.
- Run an independent ERC/connectivity review and correct any defects.
Execution stopped because your ACUs ran out.
