Project Start Guidance
Thought for 23 sec
flux
I’ll proceed one verified step at a time. First, I’m only checking the handheld’s current routing state and fresh DRC results; I won’t modify anything until that exact baseline is known.
Worked for 17 sec
flux
Baseline complete: 9 airwires, 1 copper overlap, and 6 ERC errors. Following the required order, I’ll fix only the single P1 copper overlap next, then rerun that one check before touching routing.
Worked for 7 mins 6 sec
flux
First step complete: the P1 copper overlap is fixed and verified.
- Replaced the offending
HH_ILIMtrace with a clearance-safe route. - No components or protected USB-C differential copper were changed.
- Airwire count remains 9.
Next step will be addressing one airwire only.
Start the next step
Thought for 16 sec
flux
Next step: I’ll route only the RXD airwire, keep all placement fixed, and then rerun the airwire and copper checks before proceeding further.
Thought for 9 mins 48 sec
flux
The RXD routing attempt was blocked by local congestion. The test route was fully reverted, leaving the board unchanged at 9 airwires and 0 copper overlaps.
Next single step requires approval: reduce RXD only from 0.15 mm to 0.13 mm trace width to create a legal escape path without moving components. Approve this rule adjustment?
Waiting for input
