Rotate Components 90 Degrees

B

bryan

rotate a further 90deg clockwise, but using rewrite_layout_rules tool instead

flux

Done — I rotated R1, C1, and C2 a further 90° clockwise using rewrite_layout_rules, setting their rotationZ to 180°. DRC still only reports the existing 3 airwires; no overlapping-copper or dangling-trace issues were reported.

flux

  • Set R1's rotationZ to "180deg"
  • Set C1's rotationZ to "180deg"
  • Set C2's rotationZ to "180deg"
B

bryan

remove all rotation from all components

flux

Removed all explicit rotation rules from all 3 PCB components: R1, C1, and C2.
Run DRC check
Re-place components
Inspect R1 layout
Export STEP model

flux

  • Removed R1's rotation layout rule
  • Removed R1's rotationZ layout rule
  • Removed R1's rotationX layout rule
  • Removed R1's rotationY layout rule
  • Removed C1's rotation layout rule
  • Removed C1's rotationZ layout rule
  • Removed C1's rotationX layout rule
  • Removed C1's rotationY layout rule
  • Removed C2's rotation layout rule
  • Removed C2's rotationZ layout rule
  • Removed C2's rotationX layout rule
  • Removed C2's rotationY layout rule
Sign up to send

Files

Schematic

Layout

3D View

R1
P1
C1
C2
Layout Update Notes
  • Restored R1 from Bottom layer at 90 deg to Top layer at 0 deg.
  • Applied Top layer assignment to all PCB component elements.
  • Verification target: all components on Top layer and no new placement-related DRC issues.