The router found a solution, but saving the routed traces back into the project timed out. I’m checking the board state now to see whether any routing was applied and whether there are remaining issues.

Routing is blocked by the routing service: the first pass found a route but timed out while saving it, and the second attempt was rate-limited before it could start. The board is still placed and ready; current review still shows the same unrouted connections because the routed result was not saved.

Next best step is to retry routing after the service rate limit clears, or route manually from the current 70 × 55 mm placed layout.

try again

I retried the router, but the routing service rejected the new job before it could start. Per the routing retry guidance, I’m stopping here rather than repeatedly rerunning an expensive job: the placed 70 × 55 mm board is intact, but the traces were not saved, so the board still has unrouted connections.

Next step: retry auto-routing later once the service clears, or manually route the 14 remaining connections from the current placed layout.