Getting Started with Flux


I started the circuit in your project and rendered the existing 3D enclosure. The complete circuit is not finished yet.
Current 3D model

DrainCheck enclosure with cover lifted

3D Model

The enclosure retains four corner screws. The blue shapes represent estimated electronics sizes—not detailed circuit boards. Actual board mounting, wiring fit, and closure strength remain unverified; it is not print-ready.
Circuit work completed
  • Added the U1.
  • Added and wired two 10 kΩ echo-input pulldowns: R1 and R2.
  • Preserved the planned upstream D4/D5 and downstream D6/D7 interfaces.
  • Marked unfinished sensor connections HOLD.
Remaining: SEN0208 has no matching library part. Completing the drawing requires a source-backed sensor symbol—not a substitute. Manufacturer supply and interface guarantees are still needed before purchase or power-up.
Checks report three unfinished single-pin nets and one VIN power finding; the latter reflects the module symbol’s omission of built-in USB power. No custom PCB or physical testing was completed. I saved the checkpoint in the Project Specification.
Execution stopped because your ACUs ran out.

Waiting for input


Schematic of DrainCheck — Drainage Diagnostics Pilot
R2
Resistance
10kΩ
U1

DrainCheck — Drainage Diagnostics Pilot