The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

USB Type C Connector Receptacle for USB Type C plugs. USB-C Features The USB-C interface has three main features: It has a flippable connector. The interface is designed in a way that the plug can be flipped relative to the receptacle. It supports USB 2.0, USB 3.0 and USB 3.1 Gen 2 standards. Moreover, it can support third-party protocols such as DisplayPort and HDMI in a mode of operation called Alternate Mode. It allows the devices to negotiate and choose an appropriate level of power flow through the interface. In the following sections, we’ll see how these features are provided by the USB Type-C standard. The USB Type-C Receptacle/Plug Pins The USB Type-C connector has 24 pins. Figures 1 and 2, respectively, show the pins for the USB Type-C receptacle and plug.

Connector for USB Type C. In addition this connector includes the receptacle and plug part circuit diagrams for the pins in the part to integrate it in other diagrams.

A simple voltage divider to showcase how to make parts. A voltage divider is a simple circuit which turns a large voltage into a smaller one. Using just two series resistors and an input voltage, we can create an output voltage that is a fraction of the input. Voltage dividers are one of the most fundamental circuits in electronics.

Simple Coaxial Power Plug Connector 8mm size. Barrel connectors provide only two connections, frequently referred to as "pin" or "tip" and "sleeve". When ordering, there are three differentiating characteristics of a barrel connection- inner diameter (the diameter of the pin inside the jack), outer diameter (the diameter of the sleeve on the outside of the plug), and polarity (whether the sleeve voltage is higher or lower than the tip voltage). Sleeve diameter is most commonly either 5.5mm or 3.5mm. Pin diameter is contingent upon sleeve diameter; a 5.5mm sleeve will have either a 2.5mm or 2.1mm pin. Unfortunately, this means that a plug designed for a 2.5mm pin will fit in a 2.1mm jack, but that the connection will be, at best, intermittent. 3.5mm sleeve plugs usually mate to a jack with a 1.3mm pin. Polarity is the final aspect to consider; most often, the sleeve will be considered 0V and the tip will be a positive voltage relative to the sleeve. Many devices will have a small diagram indicating the polarity expected by the device; care should be taken to adhere to this, as an improper power supply may damage the device.