PWM Controlled LED Circuit
Thought for 2 mins 4 sec
Here are the net connections to properly wire the PWM-controlled constant-current LED circuit:
Table
| Net | Connections |
|---|---|
| Net 5 | J1:Pin_2, LED1:Cathode, U1:VIN |
| Net 3 | U1:GND, J2:Pin_2, LED1:Anode |
| Net 2 | U1:SW, L1:1 |
| Net 1 | L1:2, J2:Pin_1 |
| Net 6 | U1:CSN, R1:1, R2:P1 |
| Net 4 | U1:DIM, C1:1, C2:P1 |
Apply these changes?
Thought for 52 sec
applied changes.
Thought for 37 sec
Which Arduino pin would you like to use for the PWM signal to the PT4115’s DIM input?
For example, you could use digital pin 9 (
For example, you could use digital pin 9 (
~9) or any other PWM-capable IO on the Mega2560.Thought for 51 sec
I wasn’t able to find any Flux documentation on wiring one part pin directly to another via the Copilot “@help” entries. That likely means there isn’t a dedicated guide for this exact task.
You can try these resources for step-by-step assistance:
- Browse the Flux Documentation: https://docs.flux.ai/Introduction/the-flux-method
- See all search results: https://docs.flux.ai/?s=connect%20pin%20of%20one%20component%20to%20another%20in%20Flux%20schematic
- Ask in the Flux User Community: https://www.flux.ai/p/slack-community
Draw connection wire
Label net
View pin mapping
Pull-down resistor selection
Calculate resistor
