Part Information Review and Datasheet Update
Thought for 34 sec
Yes — the incomplete connections are on the PCB layout, not the schematic.
The review shows:
- Airwires: 7 errors = missing routed traces between pads
- Floating Pin: clean
- Single Pin Nets: clean
- Undriven Nets: clean
That matches Flux’s review definition: an airwire means a net is connected logically but not yet routed as copper on the board
What is already connected in the schematic:
- GND: J1 pin 2, J3 pin 2, Q1 source, R2 pin 2
- +24V: J1 pin 1, J2 pin 1, D1 cathode
- SOL_LOW: J2 pin 2, Q1 drain, D1 anode
- GPIO_IN: J3 pin 1 to R1
- GATE: R1, R2, and Q1 gate
So the issue is:
- the board still needs copper traces between those pads
- not that J1, J3, or R2 are electrically undefined
Also, when reporting project state, the right approach is to describe what is actually present and separate concerns like unrouted connections from the functional schematic state
What still needs routing
Table
Give routing order
Check all DRC
Show board summary
