Diseño de PCB para Raspberry Pi CM4

turgeonjeanfrancois

turgeonjeanfrancois

ok is this template good for compute module 5 also

flux

Short answer: not automatically.
This template is clearly set up around the CM4 connector approach, using J1 and J2, both J1. So it is a good starting point only if a future CM5 keeps:
  • the same mechanical form factor
  • the same two 100-pin board-to-board connectors
  • the same pinout
  • the same power rails and boot/interface behavior
If any of those change, then a CM4 template will not be a drop-in base for CM5.
For your current project, the safest assumption is:
  • use this template for CM4
  • do not assume CM5 compatibility until its official hardware documentation confirms it
Practical rule:
  • If CM5 is pin-compatible with CM4, this template is likely reusable with minor review.
  • If not, you would need at least a connector/pinout/power rework.
If you want, I can help you make this design CM4-optimized only, or help you define it in a more future-tolerant way.
CM4 only for now
Future-proof interfaces
Check connector assumptions
Sign up to send

To get started, talk to Flux or create a New Document.

Documents

    Documents are markdown text files which describe project goals, capture details, or even simulation outputs.

    Assets

    tesdf.png

    tesdf.png

    tesdfThumbnail
    stp

    CM4-step.stp

    CM4-step3D Model

    CM4 Template

    CM4 Template thumbnail
    This is a template for easy and fast developing HAT for RPI CM4! #RPI #CM4 #Template

    Properties

    creativecommons.org/licenses/by/4.0/

    Pricing & Availability

    Distributor

    Qty 1

    Controls