copilot

• Connection Specifics:
  • Connect VCC to ESP32:3V3.

• Ground Connections:
  • Connect GND to ESP32:GND.

copilot

• Connect ESP32:3V3 to $VCC$.

meryam-badour

copilot

1. Open Flux and load your project.
2. Select the "Wiring Tool" from the toolbar.
3. Click on the ESP32 module on the 3V3 pin.
4. Drag the wire to the VCC pin on the SparkFun GNSS-RTK Dead Reckoning Breakout - ZED-F9K module.
5. Click to place the wire.

copilot

1. Select the Component:
   • Find the pin of the first component you want to connect. This can be done by clicking on the specific pin.
2. Start the Connection:
   • Click on the pin you want to begin the connection from. This will usually highlight or select the pin and may start a net (wire).
3. Drag the Connection:
   • While holding down the left mouse button, drag from the starting pin to the destination pin of another component. You should see a wire following your cursor.
4. Complete the Connection:
   • Release the mouse button on the destination pin to complete the connection. The wire should now connect both pins.

• Connect $\text{MOSI/CFG\_COM0:14}$ to $\text{MISO/CFG\_COM1:15}$.

Connect MOSI/CFG_COM0:14 to MISO/CFG_COM1:15.