The screenshot shows a work-area rectangle, not a defined 25 mm × 25 mm PCB outline. Agent mode is needed to create the real board outline and place the components; since this project is view-only, I may first need to fork it into an editable copy. Click Continue in Agent Mode to proceed.
I’ll create the real 25 mm × 25 mm PCB outline, then place the existing footprints inside it without routing. Since the current project is view-only, I’ll first make an editable copy if required.
Worked for 5 mins 36 sec
Created a thread; Forked a project
nRF52810 25mm BLE Beacon
Ultra-Low-Cost nRF52810 BLE Beacon with 32 MHz Crystal, PI RF Matching Network, Meandered 50-Ohm PCB Antenna, SWD Pads, and CR2032 Coin-Cell Power
The board outline and component placement are now applied in the editable copy. I’m checking the final geometry and confirming that no routing was introduced.
Configured 2-layer stackup with bottom copper designated as ground plane.
Placed U1 centrally and arranged the crystal, decoupling, and L1–C5–L2 RF network.
Confirmed no traces were added and no placed components overlap.
Open item: J1’s footprint is 34.5 × 18.1 mm, so it physically cannot fit on the 25 mm board. It remains outside the outline until replaced with a smaller CR2032 holder or the board size is increased.