Power Converter Schematic


I’ll arrange all PCB components by functional power stage, safety isolation boundaries, current-loop length, thermal needs, and connector access, then verify placement/DRC. I’ll keep the transformerless mains and 12 V battery domains clearly separated and treat this as an unrouted placement pass.
I prepared the full placement plan, but no PCB changes were applied because the account has no available ACUs.
Remaining
  • Size/configure the board and 4-layer stackup
  • Place all 99 components by functional and safety domains
  • Verify overlaps, board bounds, creepage, and DRC
This transformerless mains design must maintain strict separation between HV, battery, and user-accessible control areas.
No PCB analysis or auto-layout changes could be performed because the account currently has no available ACUs.
Remaining work:
  • Inspect the current board for existing placement and routing
  • Configure the board outline/stackup if absent
  • Auto-place all components with mains creepage, thermal, and high-current-loop constraints
  • Route required nets and verify DRC, airwires, and safety clearances
Explain ACUs
Manual inspection help
Check ERC first
Set board manually

Waiting for input


Block Diagram
Power path

Text


230 VAC L/N/PE
  → input connector + 1 A fuse + 2 A breaker interface + 275 VAC MOV
  → NTC / relay-bypassed precharge
  → 3 mH common-mode / differential EMI filter + 100 nF X2 capacitors
  → isolated grid-voltage and Hall grid-current sensing + PQA connector
  → two-pole grid contactor with isolated coil driver and auxiliary feedback
  → LCL: 2 mH grid choke – 5 µF AC-rated damped shunt – 2 mH bridge choke
  → 650 V full bridge (four switches, isolated gate channels, dead-time/interlock)
  → 325–400 V DC link (≈470 µF / 450 V bank, bleeder + active discharge)
  → four-switch non-isolated bidirectional buck/boost (650 V HV leg, 80–100 V LV leg, 100 µH / ≥15 A inductor)
  → reverse-polarity protection + ≥15 A fuse + battery disconnect
  → 10.5–14.4 V battery / BMS connector
Control and sensing path

Text


PYNQ-Z2 3.3 V headers (SELV-side external board)
  ↔ digital isolators / optocouplers
  ↔ hazardous-domain PWM, enable, dead-time, relay, ESTOP and fault logic

Grid voltage, grid current, DC-link voltage, battery voltage/current, temperature
  → isolated sensors / isolated amplifiers
  → conditioned 0–3.3 V feedback connector to PYNQ
Safety boundary
The complete converter power stage, battery terminals, BMS signals, hazardous-side driver supplies, and hazardous-side sensing circuits are potentially mains referenced. Only explicitly isolated interfaces to the external PYNQ-Z2 may be treated as SELV. Protective earth is provided only for enclosure/shield/Y-cap returns and must never be used as control return.
Reference matching decision
This unusual full-system converter has no assumed reusable monolithic reference block. Each power/protection/control block will be captured from scratch using library parts where exact pinouts are available and rating-explicit generic/reference symbols where exact power parts are unavailable. The design remains a teaching reference rather than a certified implementation.
  • Power path

  • Control and sensing path

  • Safety boundary

  • Reference matching decision