Raspberry Pi LED Wiring
Worked for 8 mins 10 sec
The completion executor finished its correction/routing pass. Before that pass, I confirmed the board was 65 × 56.5 mm but had an out-of-bounds Pi header, overlapping copper, severe congestion, and 19 unrouted connections.
Remaining
- Independently inspect the executor’s final placement and routing
- Re-run ERC/DRC to confirm zero airwires, overlaps, and out-of-bounds parts
- Verify Pi 3B+ header and mounting-hole geometry
I can’t perform those final checks because no ACUs are currently available.
Received notification from "Raspberry Pi HAT PCB" that it finished — picking the work back up.
Thought for 2 sec
The Raspberry Pi HAT PCB executor reports the correction/routing pass completed, but I cannot independently inspect or reconcile the resulting board because the account currently has no available ACUs.
Still required before fabrication:
- Re-run ERC/DRC and confirm zero airwires, shorts, overlaps, and out-of-bounds items
- Verify Pi 3B+ header and mounting-hole geometry
- Review trace widths, ground return paths, connector labels, and top-side assembly
- Generate manufacturing files only after those checks pass
Review board state
Check ERC and DRC
Verify HAT mechanics
Prepare fabrication checklist
